18
3.
Pull the top of the solution tank away from
the i-mop® body (Figure 12, pos 1).
4.
Take out the desired pod (Figure 12, pos 2).
5.
Push the the solution tank back onto the
i-mop body.
6.
Place the pod in the pod injector with the
i-dose logo facing upwards
(Figure 11, pos 2).
7.
Close the injector top.
Figure 12
ATTENTION
Dispose of the empty i-pods in an appropriate waste container for PE plastics.
6.2
Filling the solution tank
When the solution tank (Figure 13, pos 1) is
empty, you can remove it to fill it.
1.
Take the solution tank (Figure 13, pos 1) by
the injector (Figure 13, pos 2).
2.
Remove the solution tank as indicated by
the arrows.
3.
Fill it with water, see (Figure 8, pos 1).
4.
Place the solution tank back on the i-mop
body.
Figure 13