19
5.2
Assembly
1.
Place the i-fogger® on a level surface.
2.
Place the disinfectant solution tank
(Figure 8, pos 2) on the i-fogger. Press it
downwards to make sure that the valve
(Figure 8, pos 3) is secured onto the valve
stem (Figure 8, pos 4) on the i-fogger body.
3.
Press the top of the disinfectant solution
tank against the i-fogger body. The magnet
(Figure 8, pos 1) locks the disinfectant
solution tank in place.
Figure 8
4.
Open the hatch (Figure 9, pos 4) in the body
of the i-fogger.
5.
Ensure that the i-fogger is turned off. To do
this check the ON/OFF switch on the
i-fogger body (Figure 9, pos 1).
6.
Insert the battery (Figure 9, pos 3) in the
battery slot (Figure 9, pos 2), until you hear a
"click". The battery is now fixated.
Figure 9
