21
6
Operation
6.1
Before you start
ATTENTION
Make sure that the battery is fully charged before you start. Please refer to the user
manual of the i-charge® 9 or i-charge® 14, depending on which type of battery you use.
FIRST TIME USE
If you use the i-fogger® for the first time, please allow the disinfectant solution to work
its way through the system. This might take some time.
6.1.1
Checking and topping up the disinfectant solution level
1.
Place the i-fogger® on a level surface.
2.
Visually check the level of disinfectant
solution in the disinfectant solution tank.
3.
If the level is low, remove the disinfectant
solution tank from the i-fogger main body.
4.
Pull the top of the disinfectant solution tank
towards you (Figure 11, pos 1).
5.
Remove the disinfectant solution tank
(Figure 11, pos 2) by pulling it up slightly.
Figure 11
6.
Turn the filler cap (Figure 12, pos 1) of the
disinfectant solution tank anti clockwise to
remove it.
7.
Pour in the disinfectant solution.
8.
Turn the filler cap of the disinfectant solution
tank clockwise to lock it. Make sure it seals
tight.
9.
Replace the disinfectant solution tank on the
i-fogger main body.
Figure 12