21
6.2
Start
1.
Put the main power cable into the wall socket (Figure 17, pos 1).
2.
Press the ON/OFF switch (Figure 17, pos 2) to start the i-vac 5®. The green light in the ON/OFF
switch will go .
3.
Take the wand from the holder (Figure 17, pos 3).
4.
Start vacuuming.
Figure 17
6.2.1
After operation
1.
Press the ON/OFF switch (Figure 17, pos 2) to switch off the i-vac 5.
2.
Remove the main power cable from the wall socket. (Figure 17, pos 1).
3.
Wind the main power cable around the head of the i-vac 5 (Figure 17, pos 4).
4.
Place the yellow cable clamp (Figure 17, pos 5) over the cable.
5.
Place the wand back in the holder (Figure 17, pos 3 ).
