iCylinder2 SFT05 - Software
v1.0
iTEC
– PORTUGAL
www.i-tec.com.pt
18
5.10 Typical Operation
5.10.1 Handset Time Setting
There are two kinds type for handset time setting: one is same with PC time, the specific operation please
reference to <<5.5 Update Handset Time>>,
the other is handset with its own time function, the specification operation as following shows:
Select 1.1 "Setup Time" to set the handset time, which function is used for update lock time but without update
time on the PC
5.10.2 Clear Handset Records
Select "1.2 Clear Records: can clear the handset records";
5.10.3 Binding and Unbinding
Select 4.1 "Unbind Cylinder" can unbind the handset with cylinder, and then can use other handset to bind with
cylinder,
the communication prompt as following shows:
PS: Every lock only corresponding with one handset, and when the lock communicates with handset at first time,
which will bind with each other automatically, that is to say, other handset can not operate to this lock;
5.10.4 Handset Emergency to Open Door
Select 4.2 "open room" can use the banded handset to open the rooms.
5.0.5 Prohibiting to Swiping Card
Select 4.3"Disable Card" can prohibit all of users open the rooms in special situation;
Note:
1. when the cylinder communicates with the handset, please using handset inductive area to press the cylinder
inductive areas
(iCylinder inductive area located in cylinder antenna part),and keep this state until the communication successful,
sometimes the communication perhaps failure for its bad signals;
2. When handset communicates with Lock, put the handset in the inductive area on the icylinder/Lock handle
inductive area.
3. Press "ON/OFF" for 3 seconds, the handset will be opened or closed, without any operation during the 30
seconds, the handset will enter standby mode,
and if without any operation during the 60 seconds, the hand-held terminal will be closed automatically.