i-tec MySafe CAMYSAFEDUAL35, User Manual

4 |

MySafe USB 3.0 / USB-C 2x 3.5

″

 HDD RAID External Case

ENGLISH

SPECIFICATION

•  External USB 3.0 case for 2x 3,5” SATA I / II / III hard drives

•  Transmission interface: 1x USB 3.0

•  Compatible with all 3.5“ SATA HDD (up to capacity 8 TB)

•  Compatible with USB-C interface with included USB-C to USB 3.0 cable

•  Plug & Play function support 

•  Active LED diodes indicating the case state (illuminates - is connected, 

fl

ashes - a 

writing/reading procedure in progress) 

• RAID 

fi

eld switch

•  Power supply 12 V, 4 A

• Fan

•  Weight: 458 g

•  Dimensions: 180 x 113 x 64 mm

PACKAGE CONTENT

•  External case for 2x 3,5” HDD/SSD

•  USB 3.0 cable - length 80cm

•  USB-C to USB 3.0 cable - length 80cm

• Screw-driver

• Screws

• Stand

• User manual

SYSTEM REQUIREMENTS

•  Windows 7/8/8.1/10 32/64bit – automatic installation of the drivers from the system

•  Mac OS 10.x and higher – automatic installation of the drivers from the system

•  Linux, Android, Chrome – automatic installation of the drivers from the system

•  Free USB-C or USB-A port

SATA HDD HARDWARE INSTALLATION

Proceed according to the following instructions:

1. 

Eject the inner part with the motherboard.

2. 

Attach HDD to the motherboard.

3. 

Inserted HDD screw on both sides.

4. 

Put this set back to the case and screw it on the bottom part.

5. 

Put the case into stand

6. 

Connect the USB 3.0 or USB-C/A cable to the case and to the computer.

7. 

Set the RAID 

fi

eld - see article "RAID 

fi

eld setting"

8. 

Detection and automatic installation will be performed.

9. 

Device is ready for use now.

RAID FIELD SETTING

Attention: By changing the setting, you will always lose your already saved data.

1. 

At the switch, select one of three options of connection of the disks in dependence 

on the need of use. 

 A)

 Raid 0 – stripping/sum of disks, writing to the both simultaneously, interlaced 

(

fl

ash the both LED). A bene

fi

t is a high writing/reading speed. Attention: In case of a 

failure of one of the disks, all data will be lost

 B)

 JBOD/separate disks – There is reported as two separate disks in the system 

(

fl

ashes LED depending on a disk to which the record is being performed)

 C) 

Raid 1 – Mirroring (both LEDs 

fl

ash at writing, in case of reading - just one). In case 

of a failure of one of the disks, data will not be lost.

2. 

While the case is connected and switched-on, push the Reset button for 5 seconds. 

The RAID 

fi

eld will be readjusted.

3. 

Format the disks.