VT1000 USER MANUAL
8
◆
GPS Vehicle Tracker Installation
GPS tracker should be installed by technical professional of local service centre. Without permission, the user
cann’t repair and move the tracker randomly. If users do, any unfortunated damage should be compensated by
himself.
Installation steps (caution: the following installation should under no power, otherwise will be dangerous)
1.Power supply line: The red wire connects 12V“+”;Black wire connects to GND“-”
2.Connection shock sensor.(Orange Wire)
3. Wire for cutting off oil of the tracker(Yellow Wire)
Yellow wire connects the relay pin 86; 85 pin connect to 12 V DC , 87a pin and 30 pin in series power supply
circuits. Caution: Wrong connection of yellow wire will damage the tracker.
4. Wire for cutting off circuit of the tracker(White Wire)
White wire connects relay pin 86; 85 pin to 12 V DC, 87a pin and 30 pin are in series power supply circuits.
Caution: Wrong connection of yellow wire will damage the tracker.
5. Emergency triggering (SOS) alarm (Blue Wire)
The blue wire connects the positive of the alarm button, and the black wire connects the negative of the alarm
button.
6. Vehicle door detect, low level trigger (Gray Wire)
The Gray wire connects with Door sensor
.
