25
Install video codec:
Install the video codec of this IP camera when you connect IP camera at first
time, if the IP camera canno
t display the video on the screen.
Vendor & Model:
Select the correct brand and model for the connected IP camera. You also can
select “Onvif
”
if your IP camera support Onvif compliant and not on the list. You can check the
used camera support Onvif compliant from: http://www.onvif.org. Click “
Onvif setup
“icon to
setup the parameters or entry RTSP command code directly which you want to run on the Hybrid
DVR or NVR.
Compress:
Select the suitable codec for video recording and transmission.
Recording resolution:
Select the resolution for video recording and display.
Frame rate:
Select the frame rate for video recording and display
.
Rate Control:
You can choice video quality or bit rate from this tab. Good video quality or large
bit rate request bigger storage capability.
IP address:
Entry the correct IP address for the connected IP camera. If you do not know the IP
camera’
s IP address, you can click
“
Find
”
icon to find out the currently connected IP cameras
User name & Password:
The user name and password must be matched the setting of IP camera
which you want to connect.
Find:
Click this icon to find out all the currently connected IP cameras on the list. Click the IP
camera and find out the information of each IP camera. Please refer the diagram shown as above
Fig D.
Click the IP address and “
Select
”
icon, the network information of this IP camera will be
added for this channel. The Fig D diagram please refers to “
1. Setup the parameters of All IP
cameras (For I-View’s IP camera only)”
Section
Advance setup:
Click this icon will enable the detail parameters setting of IP camera. You need to
load the Active X if this NVR is activated this process at first time.
The difference IP camera brand has its own “
Find
”
and “
Advance setup
”
setup diagram and
setting process. For the detail information
,
please refer to the IP camera operation menu.
HTTP port & RTSP port:
The both port number must be matched the setting of IP camera which
you want to connect.
Display streaming:
You can select the “
Dual streaming
”
or “
None
”
mode
; If you select the
“
Dual streaming
”
mode
, the live display video will show lower
resolution for split video and
higher resolution (same as recording resolution) for pop-up to single video on the screen. This
Summary of Contents for ANYCAM DM-2MIPR04 Series
Page 18: ...18...
