49
Area Setting:
Click “
Drawing
“
icon, then p
ress and drag the left Mouse button to setup the
detection region from Area Setting section. Click the right button to complete the detection region
setting
Clear:
Click Clear to delete all detection regions
Detection Area:
To add new Detection Area (Max. 4 regions) and each line can setup individual
corresponding parameters.
Detection Type:
There are “Target Entry
”,
“Target Lave
”,
“ Target Enter/Leave
”
and “Target Loiter
”
modes
, and choose
one for the detection type.
Object Percent:
Setup the minimum percentage ration (target size/ image area) of effective
counting targets. Once the targets ration is smaller than the setting value, th
e system will ignore the
target which passing through the trigger line.
Time:
Set the upper limit value for the Target leave or enter or stay period
,
the alarm will be
triggered automatically when the value is more than the setting.
Email:
Check “Email
”
and once the event triggers that it will send Email to setting email address.
Alarm Output:
Check “Alarm output
”
and once the event triggers
, the camera will
linkage to alarm
output.
PTZ:
Check “PTZ
”
and once the event triggers, the camera will
linkage PTZ camera to move the
assign Preset point.
Preset:
Setup the Preset point for the PTZ camera move to when the event is triggered.
Save:
Click “
Save”
icon to store the setting.
Summary of Contents for ANYCAM DM-2MIPR04 Series
Page 18: ...18...
