1. Analogue Output (
Balanced:
XLR;
Unbalanced:
RCA)
2. Digital Outputs (
Optical:
Toslink;
Balanced:
AES/EBU;
Coaxial:
RCA)
3. IEC Mains Inlet Socket
4. Voltage Label
5. AC Mains Fuse Holder
6. AC Mains Power Switch
SETUP
CONNECTING MAINS POWER
Please refer to the rear panel view
.
The IEC connector of the supplied mains lead should be
plugged into the socket
(3)
on the rear of the unit first and then plugged into the mains supply.
The Mains power switch
(6)
is on the rear panel of the CD Player. This switch is normally left
on. If the unit is likely to be unattended for a long period, switch it off and unplug the mains lead
from the wall.
SIGNAL CONNECTIONS
ANALOGUE OUTPUT:
The Analogue Output uses Gold plated RCA Phono sockets or XLR connectors and should be
connected to the CD or LINE input of your Preamplifier or Amplifier.
DIGITAL OUTPUT:
The Digital Output
(2)
uses a Gold plated RCA Phono socket for Coaxial SPDIF and Toslink
for Optical and XLR for Balanced AES/EBU output. Any of these could be connected to a
corresponding input of an amplifier with a digital input, or to an outboard Digital to Analogue
converter (DAC).
IMPORTANT NOTE:
For optimum performance it is recommended to use high quality
inter-connect cables for HI END audio.
OPERATION
Please refer to the rear panel view
.
SWITCHING ON
The Mains power switch
(6)
is located on the rear panel of the CD Player. This switch should
be left ON for normal operation. If unattended for a long period, the Mains power should be
switched OFF and the lead disconnected from the power supply.
When switched ON from the rear panel, your CD-22 CD Player Display will illuminate in few
seconds.
Summary of Contents for LITE CD-22
Page 1: ......
