www.i2systems.com
Integrated Illumination Systems, Inc.
355 Bantam Lake Road
Morris, CT 06763 USA
tel +1.860.567.0708
fax +1.860.567.2501
sales@i2systems.com
Product information is subject to change without notice.
All brand names and product names are trademarks of i2Systems.
© 2012 i2Systems. All Rights Reserved.
Gen3
Installation Guide
9
The input cables and end caps are required if you are installing a Gen3 Fixture equipped with the
connector Plug-Together option. Note that extension cables are optional for these installations.
Plug-Together Cables for the Gen3
(Optional)
End Cap
(Need 1 Per Continuous Run)
720-02050
Input Cable
(Need 1 Per Continuous Run)
15 Ft: 685-02046-15
Extension Cables
(Optional)
1 Ft: 685-02048-1
3 Ft: 685-02048-3
15 Ft: 685-02048-15
Select the bracket appropriate for your installation.
• Use one of the adjustable brackets, VLA-14 or VLA-5, to set the angle at which
the light washes or grazes over a wall and ensures the ability to change this angle in
the future.
• The use of the VLAX2-6 or VLAX2-12 offers similar performance to the VLA-14, however
extends the Fixture away from the mounting surface as shown on page 10.
• Use VLA-15 for fixed installations at 90⁰ relative to the mounting surface.
In installations where the Fixture is at risk of falling, install a properly rated safety strap or cable
using a #8 screw (not supplied with this Fixture) in any of the drilled and tapped holes available
on the backside of the Fixture.
Fixture Installation
Summary of Contents for Gen3 V3285
Page 1: ...Gen3 V3285 Installation Guide ...
Page 20: ......
