17
Rev. 130411
i3-TRNG-CAMS-Ax51B.indd
Basic Setup is divided into Camera and Network settings. Settings that can be
configured in this setup tab:
Camera Settings:
•
Camera Name: The name of the camera will be displayed at the top of the
Internet browser page.
•
Video Codec: Set the compression mode to MJPEG, H264 or MPEG4
•
Resolution: Set the resolution of the recorded video to D1, SVGA, XGA, 720P,
SXVGA or 1080P (full HD).
•
Bit Rate (for H264/MPEG4 codecs): Set the video bit rate from 500-8000 kbit/s
•
Quality (for MJPEG codec only): HIGH, NORMAL, LOW
•
Frame Rate: Set the frame rate for the recorded video to 1, 3, 7.5, 10, 15
(available only with 1080P resolution), or 30 fps (unavailable with 1080P
resolution)
Network settings:
•
DHCP: Enable or Disable to have the network automatically assign an IP address
to the camera.
•
IP Address: Manually enter the camera’s IP address here.
This option should NOT be used if DHCP is enabled.
•
Subnet Mask: Manually enter the camera’s Subnet Mask here.
This option should NOT be used if DHCP is enabled.
•
Default Gateway: Provide the IP address of the network’s router if necessary.
Contact your network administrator for this information.
•
DNS: Specify a DNS if necessary.
Contact your network administrator for this information.
•
Physical Address: This is the camera’s unique MAC Address. It may not be
changed.
6.2 Video Setup
Switch to the Advanced Setup by clicking the
Advance Setup
button on the
bottom left-hand corner of the screen as shown on the previous page. The Setup
screen will change to reveal multiple setup tabs. Video Setup tab is displayed by
default.
