7
Rev.
130130
i3-TRNG-CAMS-
Di721/Do721
.indd
Figure 3-1
1. Conduit holes used for surface run power/video connector
a. Side conduit hole (1/2”).
When using outdoors, sealant must be used to maintain the IP67 status.
b. Top conduit hole (3/4”) (can also be used for pendant mount).
When using outdoors, sealant must be used to maintain the IP67 status.
2. Bottom case
3. Camera Base
4. Dome cover
5. Focus lever
6. Zoom lever
7. Video output connector
8. 24 VAC / 12 VDC power input connector (red +, black -)
3.2 Routine Maintenance
•
The dome cover is an optical part. Use a soft and dry cloth to remove any
fingerprints and dust.
•
Clean the camera housing with a soft and dry cloth. For more stubborn marks,
use a cloth dampened with a small quantity of neutral detergent, then wipe dry.
3.3 Disassembling the Camera
Before you mount and adjust the camera, follow these steps to disassemble the
camera.
1. Use a Security Torq Screwdriver to remove the dome cover.
Figure 3.2 Disassembling the camera