System Setup > Event Settings
Revision: 180906
Veo16i User Manual
Page | 77
>
NOTE:
If motion detection occurs at the same time on multiple cameras, the video popup will
display all cameras with current motion in the smallest suitable screen division rather than in full
screen mode. E.g. Two motion detection channels will be shown in a 2x2 screen division.
>
OSD POPUP: Enable OSD popup notification for motion detection on the selected
camera.
>
EMAIL: Enable email notification for motion detection on the selected camera.
>
FTP: Enable FTP email notification for motion detection on the selected camera.
Click
APPLY
to save new configurations.
When done, click
CLOSE
or press [
EXIT
] on the remote control.
Video Loss
<SYSTEM SETUP> - <EVENT> - <VIDEO LOSS>
Link video loss event on specified cameras with Alarm Out (Control/Relay). Enable notification options
for each individual camera’s video loss event.
>
IGNORING INTERVAL: Set video loss detection delay time. This option helps control the
frequency of linked video loss notifications. If you are receiving too many video loss
notifications, increase this interval setting. By default, this option is set to IMMEDIATELY (no
delay).
>
ALARM OUTPUT: Link the video loss event with one or more of the connected Alarm Out
(Controls/Relays). By linking Alarm Out with a video loss event, you can activate the connected
Alarm Out device when video loss event occurs.
>
PRESET: Link the video loss event with
cameras. Every time video loss event occurs on the selected camera(s), the linked PTZ
camera(s) will go to the linked preset.
>
Enable one or more video loss event notifications. Refer to
information on BUZZER, EMAIL and FTP notification configurations (Optional).
>
BUZZER: Enable buzzer alarm notification for video loss event on the selected camera.