1.4.1 Functioning principle of the device is to reverse the flare effect. The device emits light and registers the
back coming radiation (including the reflected glare from the lenses of hidden cameras). As the brightness of
the camera lens reflected ray is several times higher than the reflection from other objects, it is easy to
determine camera location.
1.4.2 The product is based on a microcontroller with preinstalled software.
1.4.3 Device power supply is realizes using the battery or the supplied external power source (AC adapter)
with an output voltage DC 5V C. The external power supply is connected through the socket (see Picture 2).
The polarity of the socket is shown on Picture 3
Picture 3 – socket polarity for external power supply connection
Note:
the battery is developed for the entire device life and does not require replacement during the
operation.
2.
Intended use
2.1 Operating limitations
2.1.1 It is prohibited to direct the device to your own or another person’s eye.
2.1.2 When storing the product in cold place or winter transportation the device should be kept at room
temperature for two hours.
2.2 Use of Products
WARNING! Before the first use, please, charge full battery with the network adapter supplied.
2.2.1 To get a successful result, be aware, that the detection of hidden cameras depends on the frequency of
generated flares:
Switch modes (frequency of flashes) by briefly pressing the button, located on the rear panel of the product.
It is recommended to select a frequency, at which the glare of flares is most noticeable.
Current flashing mode is displayed by one of the LEDs located next to "ON / OFF" button on the rear panel
of the device.
2.2.2 Batteries must have sufficient charge for operation of the device. If SOC reaches its minimum level
while functioning, the LEDs on the rear panel flashes for a short time and the product turns off. To continue,
you can connect an external power source
(AC adapter)
, which comes supplied with the device.
2.2.3 The external power supply (AC adapter) is also used as a charger. On the first stage charging is
realized by moderate current
(fast running light on the indicator and functioning modes)
, on the second -
current decreases
(slowly running light)
. When charge controller reaches full battery charge, the device
automatically stops charging process.
2.2.4 Although the device uses in Ni-MH batteries, which have no memory effect and can be stored
discharged, to increase their service life it is recommended charging the batteries for one cycle after they are
fully discharged.
