4
Attach the front Drawer Hanger (item D) to the
bottom of the worksurface. There are threaded
inserts in the bottom of the worksurface that will
align with the slots in the hanger. Attach the
hanger with 1/4-20 phillips head screws (item A)
and washers (item B).
Attach the rear Drawer Hangers (item E) to the
Locker Case (item 1) by threading 1/4-20 phillips
screws (item A) with washers (item B) from inside
the locker through the slots at the rear of the locker
case and then into 1/4-20 hex keps nuts (item C)
with washers (item B).
Do not tighten these screws completely as it may
be necessary to adjust the Rear Hanger Brackets.
QS-SMS SINGLE 12" LOCKER
Installation
