IAG Performance | 1203 Baltimore Blvd. Westminster, MD 21157 | Ph: 410-840-3555 | www.iagperformance.com
3
Install
:
5. Install the billet bracket on the back side of the
compressor. Please take note of the orientation of the
bracket. Using the supplied 5mm bolts and washers, screw
the bolts through the slots into the existing holes. Leave
the bolts loose enough that you can rotate the bracket
side to side.
5.
6. Please study the assembly of the linkage. The inline ball
joint is RHT and the rod end ball joint is LHT. Rotating the
turnbuckle one direction will lengthen the linkage.
Rotating the linkage the other direction will shorten the
linkage. The jam nuts should already be threaded onto the
linkage. However, if your hardware is disassembled, please
place the appropriate jam nuts on each ball joint and then
thread the ball joints into their respective sides of the turn
buckle.
6.
7. Screw the inline ball joint into the threaded hole on the
bracket.
7.