IOM9SE4 Installation and Instructions for Use
L
N
Electrical Connection
Those ovens equipped with a three-pole power supply cable are designed to operate with an alternating
current .The wire for earthling the appliance is yellow-green in color.
Fitting on a Power Supply Cable
Opening the terminal board:
·Using a screwdriver, prize the bolt on the side tabs of the
terminal board cover ;
·Unscrew the bolt, pull open the cover of the terminal board .
To install the cable, proceed as follows:
· Remove the wire clamp screw and the three contact screws
L-N –
·Fasten the wires beneath the screw heads using the following color scheme :
Blue (N) Brown (L)
Yellow-Green
·Fasten the supply cable in place with the clamp and close the cover of the terminal board .
Connecting the supply cable to the mains
Install a standardized plug corresponding to the load indicated on the data plate. When connecting the
cable directly to the mains, install an omni polar circuit breaker with a minimum contact opening of 3 mm
between the appliance and the mains .The omni polar circuit breaker should be sized according to the
load and should comply with current regulations (the earth wire should not be interrupted by the circuit
breaker).
The supply cable should be positioned so that it does not reach a temperature of more than 50
Ԩ
with
respect to the room temperature ,anywhere along its length , or protected by insulation sleeping having
an appropriate rating.
Before making the connection, check that:
· The electrical safety of this appliance can only be guaranteed if the cooker is correctly and efficiently
earthed ,in compliance with regulations on electrical safety. Always ensure that the earthling is efficient; if
you have any doubts call in a qualified technician to check the system .The manufacturer declines all
responsibility for damage resulting from a system which has not been earthed.
· Before plugging the appliance into the mains ,check that the specifications indicated on the date
plate (on the appliance and /or packaging )correspond to those of the electrical mains system of your
home .
· Check that the electrical capacity of the system and sockets will support the maximum power of the
appliance ,as indicated on the data plate .If you have any doubts, call in a qualified technician.
· If the socket and appliance plug are not compatible ,have the socket replaced with a suitable model
by a qualified technician . The latter, in particular, will also have to ensure that the cross section of the
socket cables are suitable for the power absorbed by the appliance. The use of adapters, multiple
sockets and /or extensions, is not recommended. If their use cannot be avoided, remember to use only
single or multiple adapters and extensions which comply with current safety regulations .In these cases,
never exceed the maximum current capacity indicated on the single adapter or extension and the
maximum power indicated on the multiple adapter .
The plug and socket must be easily accessible.
