—
47
—
AP-
16
00T-
PMCL
Pre-correction
Post-correction
Caution
• For FlatShading and ColorShading, the maximum amount of correction gain for all pixels
is limited to twice the amount of gain before correction. (The amount of gain cannot be
increased to more than twice the amount of gain from before correction.)
• If the area in the screen with the highest brightness level is 175 LSB or less (during 10-bit
video output), proper correction is not possible.
■
To use the shading correction function
Configure the settings as follows.
Item
Setting value
Description
ShadingCorrectionMode
FlatShading, ColorShading
Select the shading correction mode.
ShadingMode
User1, User2, User3, Off
Select the user area to which to save
the shading correction value.
Display a white chart under a uniform light, and execute [PerformShadingCalibration].
Note
After shading correction is executed, the shading correction value is automatically saved to the user
area selected in [ShadingMode].
Binning Function
The binning function allows you to combine the signal values of clusters of adjacent pixels to
create improved virtual pixels. Using the function results in images with lower pixel resolution
and higher sensitivity.
This camera performs vertical binning and horizontal binning via digital addition or averaging
processing.
ROI (Regional Scanning Function)
The ROI (region of interest) function allows you to output images by specifying the areas to
scan.
ROI Settings
Specify the area to scan by specifying width, height, and horizontal/vertical offset values
under [ImageFormatControl].
For details on how to configure the settings, see “Configuring the Output Format”.
You can increase the frame rate by specifying a lower height, as the number of lines scanned
decreases.
The setting ranges for the ROI function's readable area based on the Binning setting
(BinningHorizontal, BinningVertical) are as follows.
