4. Program Edit W
indow
115
[1] Setting of Cycle Time Measurement Area Section
(Note) The section of area to be set up should be just one section. Two or more sections cannot be
established.
(Note) When establishing the input / extension status setting, set S and E in the command (Cmnd column)
description step.
If the setting is established in the steps of only input / extension stays, it will not be subject to
measurement.
(1) Measurement Start Point and End Point Setup
[1] Right-click on Column T (blank cell) of the start step of the area section that you would like to
measure.
S: Measurement start point will be displayed.
Fig. 4.30 Measurement start point Setup
[2] Secondly, right-click on Column T (blank cell) of the end step of the area section that you would like
to measure.
E: Measurement end point will be displayed.
Fig. 4.31 Measurement end point Setup
Summary of Contents for IA-101-X-MW
