6. Position Data Edit W
indow
132
Dcl
Specify a desired deceleration.
Available range is from 1 to 9.99.
However, for X-SEL-PX/QX, 1 to 4 axes, bigger one between from 0.01 to All Axis Common
Parameter No. 23 “SCARA Axis CP Deceleration Maximum” and Parameter No. 204 “Linear Axis
Deceleration Maximum” is the setting range.
For when All Axes Common Parameter No. 18 “Maximum Operation Acceleration/Deceleration
Check Timing” is set to 0 for X-SEL-P/Q, R/S, RA/SA and SSEL or for X-SEL-J/K, JX/KX, ASEL, TT
and TTA, setting in All Axes Common Parameter No. 23 “Deceleration Maximum” and “CP
Deceleration Maximum” is the maximum value.
Comment
Enter comment, if necessary (using up to 32 single-byte characters/16 double-byte characters).
Comment can be entered for position Nos. 1 to 10000. Comment cannot be entered for No. 10001
and subsequent positions. (Supported by V9.00.00.00 or later)
In the position edit window, clicking Edit (E) from the menu bar and then selecting Undo (U)
can cancel the most recent 10 operations excluding line insertion and line deletion.
Alternatively, pressing the Ctrl key and Z key simultaneously can cancel the operations.
However, the cancel function will become disabled when any of the following operations is performed:
Transfer of data on the edit screen to the controller
Saving data on the edit screen to a file
Closing of the edit screen
When this operation is performed, the warning screen in Fig. 6.24 will be displayed.
Clicking Yes will cancel the operation executed immediately before.
Fig. 6.24 Warning
Summary of Contents for IA-101-X-MW
