8. Parameter Edit W
indow
154
8. Parameter Edit Window
8.1 Explanation of the Parameter Edit Window
(1) Click Parameter (P) from the menu bar, and then select Edit (E).
(2) The parameter edit window (Edit Parameter) will open.
You can select a desired parameter and change the value.
Values that are grayed out are read-only and cannot be changed.
Save to File
Clicking this button will open a dialog box where you can save the parameter data to a file under a
desired name.
Transfer to Controller
Clicking this button will transfer the parameter data to the controller.
Clicking this button will print the parameter data.
Click this button and you can conduct Easy Parameter Setup.
(V12.02.00.00 or later)
* The above window shows I/O parameters. You can display other parameters by clicking each category tab.
Caution: During the positioner mode of SSEL, ASEL and PSEL, the parameter cannot be
transferred in the setup status. After stopping them, change and transfer the
parameter.
For stopping, click Controller in the Menu screen, Positioner Mode and Stop.
“Driver Card”, “Encoder” and “I/O Slot Card” will be displayed
for X-SEL-J/K, JX/KX, TT, TTA and MSEL controllers.
Fig. 8.1 Parameter Edit (X-SEL-P/Q, PX/QX, R/S, RX/SX, RXD/SXD, RA/SA, RAX/SAX,
RAXD/SAXD, SSEL, ASEL, PSEL)
Summary of Contents for IA-101-X-MW
