9. Symbol Edit W
indow
176
(4) A symbol character string can be dragged and dropped between the symbol edit window and program
edit window.
By dragging a symbol character string on the symbol edit window while pressing the Ctrl key and then
dropping it into any cell of Cnd, Operand 1, Operand 2 and Pst, the symbol character string can be copied.
The reverse operation (drag & drop operation from the program edit window to the symbol edit window) is
also available.
(Supported by software version 4.0.0.0 or later)
Fig. 9.2 Symbol Edit Window Fig. 9.3 Program Edit Window
In the coordinate system definition data edit window, clicking Edit (E) from the menu bar and then
selecting Undo (U) can cancel up to the most recent 10 input operations.
Alternatively, pressing the Ctrl key and Z key simultaneously can cancel the operations.
However, the cancel function will become disabled when any of the following operations is performed:
Transfer of data on the edit screen to the controller
Saving data on the edit screen to a file
Closing of the edit screen
When this operation is performed, the warning screen in Fig. 9.4 will be displayed.
Clicking Yes will cancel the operation executed immediately before.
Fig. 9.4 Warning
Summary of Contents for IA-101-X-MW
