13
NO.
Work Description
Precautions
8
Maintenance and
Inspection
When the work is carried out with 2 or more persons, make it clear who is to be the leader
and who to be the follower(s) and communicate well with each other to ensure the safety of
the workers.
Perform the work out of the safety protection fence, if possible. In the case that the
operation is to be performed unavoidably inside the safety protection fence, prepare the
“Stipulations for the Operation” and make sure that all the workers acknowledge and
understand them well.
When the work is to be performed inside the safety protection fence, basically turn OFF the
power switch.
When the operation is to be performed inside the safety protection fence, the worker
should have an emergency stop switch at hand with him so that the unit can be stopped
any time in an emergency.
When the operation is to be performed inside the safety protection fence, in addition to the
workers, arrange a watchman so that the machine can be stopped any time in an
emergency.
Also, keep watch on the operation so that any third person can not operate the switches
carelessly.
Place a sign “Under Operation” at the position easy to see.
For the grease for the guide or ball screw, use appropriate grease according to the
Instruction Manual for each model.
Do not perform the dielectric strength test. Failure to do so may result in a damage to the
product.
When releasing the brake on a vertically oriented actuator, exercise precaution not to pinch
your hand or damage the work parts with the actuator dropped by gravity.
The slider or rod may get misaligned OFF the stop position if the servo is turned OFF. Be
careful not to get injured or damaged due to an unnecessary operation.
Pay attention not to lose the cover or untightened screws, and make sure to put the
product back to the original condition after maintenance and inspection works.
Use in incomplete condition may cause damage to the product or an injury.
* Safety protection fence : In the case that there is no safety protection fence, the movable
range should be indicated.
9
Modification and
Dismantle
Do not modify, disassemble, assemble or use of maintenance parts not specified based at
your own discretion.
10 Disposal
When the product becomes no longer usable or necessary, dispose of it properly as an
industrial waste.
When removing the actuator for disposal, pay attention to drop of components when
detaching screws.
Do not put the product in a fire when disposing of it. The product may burst or generate
toxic gases.
11
Other
Do not come close to the product or the harnesses if you are a person who requires a
support of medical devices such as a pacemaker. Doing so may affect the performance of
your medical device.
See Overseas Specifications Compliance Manual to check whether complies if necessary.
For the handling of actuators and controllers, follow the dedicated instruction manual of
each unit to ensure the safety.
Summary of Contents for IA-101-X-MW
