1. Before
You Begin
18
1.3 Installing the Software
This software is run from the hard disk. This section explains how to install the software.
1.3.1 How to Install the PC Interface Software for X-SEL
If a version of the PC Interface Software earlier than V6.0.0.0 is already installed, first uninstall the PC
Interface Software before installing V6.0.0.0.
[1] Insert the CD-ROM containing this software into your CD-ROM drive.
[2] The installed data selection screen (Fig. 1.1) will be displayed.
Click the data to install.
Fig. 1.1 Installed Data Selection Screen
(The displayed screen may vary depending on the version, data in the CD or other factor.)
* (Note) If the installed data selection screen (Fig.1.1) is not displayed:
If the Installed Date Selection Screen is not displayed after inserting the CD-ROM, please follow the next
steps to display the installed data selection screen.
a. Display the folder list in CD-ROM through the explorer etc.
Fig. 1.2 will be displayed.
Fig. 1.2 CD-ROM Folder List
b. Double-click the icon
Then Installed Date Selection Screen (Fig. 1.1) will be displayed.
Summary of Contents for IA-101-X-MW
