13. How to Reset an
Absolute Encoder
328
6) A Warning window shows up. Click “Yes”. The operation for the push type absolute reset starts.
Fig. 13.207 Warning Window
7) For the four-axis type, press Execute and proceed to “Removing”, and then take off the rotary axis
pressing absolute reset jig. At this time, make sure the work is conducted with the emergency stop
activated.
Click on the “OK” button after the work is finished.
Fig. 13.208 Jig Removing Window
8) Once the push type absolute reset for the axis is complete, the information window will appear.
Click “OK” button.
Fig. 13.209 Information Window
9) When finishing the process, click “×” on the upper right side of the window. Once the window is
closed, the parameters start to be written automatically to the flash ROM, and controller is rebooted
by the software reset.
Summary of Contents for IA-101-X-MW
