13. How to Reset an
Absolute Encoder
342
8) If it is necessary to have the Push stopper position an acquisition for another axis, move on to the
axis selection.
When finishing the process, click “×” on the upper right side of the Push stopper position acquisition
window. Once the window is closed, the parameters start to be written automatically to the flash
ROM, and controller is rebooted by the software reset.
9) Once the controller reboot is finished, conduct the push type absolute reset on the axis with the push
stopper position acquisition.
343
(2) Vertical Axis and Rotation Axis
1) Select “Individual axis” in the Push stopper position acquisition window, and set Axis to “Vert. Axis +
Rot. Axis”.
* The screenshot shows the screen for the four-axis type. Some contents should not be displayed in
the three-axis type.
Fig. 13.240 Push Stopper Position Acquisition Window
Summary of Contents for IA-101-X-MW
