15. T
ool
364
In PC Software V9.00.00.00 or later, “Maximum number of errors/warnings shown on the Edit Position
screen before transfer” is displayed.
[For the function to display errors/warnings before data transfer (common to all models), refer to 6.2,
“Saving Positions and Ending Editing.”]
The largest axis number among the axes whose data can be edited is shown after “Permit editing of
position data for all axes.”
Fig. 15.5 Environment Setup Screen (V9.00.00.00 or later)
(Note) In the case of the X-SEL-R/S, RX/SX, RXD/SXD, RA/SA, RAX/SAX, RAXD/SAXD controller, the
maximum axis number for which position data editing is permitted varies depending on how the
controller is set up.
The largest axis
number among the
editable axes is now
shown.
Set the maximum number of
errors/warnings displayed in the error
list before position data is transferred.
(Maximum setting: 100000)
Summary of Contents for IA-101-X-MW
