3. Menu W
indow
90
(10) Controller (C) (continued)
[10] Restoration of Data Written into Flash ROM (for 1 generation before) (Q)
This item is displayed for TTA, MSEL controller.
• Program (S)
Restore the program data written into Flash ROM to the written data for 1
generation before.
• Symbol (Y)
Restore the symbol data written into Flash ROM to the written data for 1
generation before.
• Position (No.10001 to 30000) (O)
Restore the position data written into Flash ROM (No. 10001 to 30000) to
the written data for 1 generation before.
Note: data cannot be restored to the position data No. 1 to 10000.
• Parameter (P)
Restore the parameter data written into Flash ROM to the written data for
1 generation before.
[11] Initialize Memory (I)
▪ Position (O)
Clear all position data.
This item is displayed on the X-SEL-R/S, RX/SX, RXD/SXD, RA/SA,
RAX/SAX, RAXD/SAXD, TTA and MSEL controllers.
(Note) If 6BD, “Position data configuration change error”, 6BF, “Position
data sum check error” or 69E, “Position data management domain
sum check error” occurs, use this command to initialize the
position data.
(Note) When XSEL-R/S, RX/SX, RXD/SXD, RA/SA, RAX/SAX and
RAXD/SAXD is connected, 22B “Position data comment loss error”
will occur if the software is reset or power is turned off after this
operation without writing the position data to the flash ROM first.
▪ Coordinate System Definition Data (C)
Clear all coordinate system definition data.
This item is displayed on the X-SEL-RX/SX, RXD/SXD,
RAX/SAX/RAXD/SAXD, TTA (Main Application V2.00 or later),
MSEL-PC/PG (Main Application V2.00 or later) and MSEL-PCX/PGX
controller.
(Note) if D40, “Coordinate system data management area sum check
error”, D41, “Coordinate system data management area ID error”
or D42, “Coordinate data sum check error” occurs, use this
command to initialize the coordinate system definition data.
▪ Global Variable and Flag (V)
Clear all global variables and flags to zero.
Summary of Contents for IA-101-X-MW
