4
6.
Operation:
Mode
Flow
Chart
Example 3: Relative Coordinates pitch movement 30 mm
→
40 mm
→
50 mm….
Operation
Screen
Reference
1. Press the
key.
2. Press the
key to select
“MDI.”
3. Set 0 into the position No. with
the
or
key.
For any unregistered data,
the display will show “*” sign.
4. Move the cursor to the “Pos” input
position with the
,
,
or
key.
5. Input
here, and then
press the Return key.
In order to stop during numeric
input, press the
key to
cancel the input.
Example)
by pressing
immediately
after inputting
,
the status will return to
6.
During new position data
registration, the initial values
set with the user parameters
for Vel, Acc, Dcc, etc., will
automatically be input.
In the left screen, the initial
value is set as 100 mm/sec.
With the left operation,
the “*” display.
Summary of Contents for Robo Cylinder CON-T
