iAIRE, LLC
iAIRE
ION Kit I/O/M
10
READ THESE INSTRUCTIONS BEFORE BEGINNING INSTALLATION
Always cut off power before mounting, removing, or cleaning the monitor.
Notice the supply power voltage of the transmitter: 24VAC/VDC. Do not install the transmitter on voltages higher than marked on
the transmitter. 24VAC/VDC.
With power off, put a flat head screwdriver deep inside of the hole on the top of the detector housing following step 1 in figure 2. Then
slant the screwdriver and gently separate the cover from the wall plate by following steps 2 through 4.
60.0
0
45.00
55.00
28.0
0
3.0
0
4.5
0
8.0
0
Figure.1
Model:
SEN-0071 - Indoor Air Quality Indicator & Transmitter
SEN-0071 INSTALL
INSTALLATION
Mounting and Wire Connection
The transmitter should be mounted near the place where you want to detect VOC level. However, do not mount the detector near a
steam source, such as a diffuser, or in direct sunlight.
2
Figure.2
Opening steps
1
3
4
IOM-0027
PD
03
/
07
/20
22
- v 01.5
1
iAIRE, LLC | 2100 Consulate Drive, Suite 102, Orlando, FL 32837
www.myultrapure.com | Toll Free 844-348-9168
