MAN-072
10
2.6
INSTALL THE CLUTCH COVER WITH
H.T. COIL
ALLEN WRENCH 5 mm
REMOVED THE 3 SCREWS TCEI M6x30 FROM
THE CRANKCASE (SEE FIG. 15) AND INSTALL THE
CLUTCH COVER WITH THE H.T. COIL.
(SEE FIG.16)
TIGHTEN THE 3 SCREW AT 8÷10 Nm
ATTENTION:
ALWAYS MAKE SURE THAT THE GROUND CABLE
ALWAYS CONNECTS THE COIL WITH THE
ENGINE. AN INADEQUATE GROUNDING
COULD DAMAGE THE IGNITION BEYOND
REPAIR.
THE POSITION OF THE H.T. COIL HAS BEEN
CHOSEN TO BE AS FAR AS POSSIBLE FROM THE
EXHAUST AS THE EXCESSIVE HEAT COULD
DAMAGE THE COIL BEYOND REPAIR.
Fig.15
Fig.16
