- 22 -
Integrated Peripherals
sub-menu of detailed options.
IDE interface with support for two IDE channels.
he choice: Disabled, Primary, Secondary, or Both.
u set a PIO mode
Slave UltraDMA:
Ultra DMA/100 implementation is possible only if your IDE hard drive
d drive and your system software support Ultra DMA/133/100,
lect Auto to enable BIOS support. The choi
ard PCI Device: Press <Enter> to enter the sub-menu of detailed options.
d you
ave USB peripherals.
The choice:
Enabled or Disabled.
controller and you have
his item allows you to control the onboard AC97 Audio. The Choice: Enabled or Disabled.
A Mode. The Choice: IDE or RAID.
Press <Enter> to enter the sub-menu of detailed options.
Onboard Serial Port1:
Select an address and corresponding interrupt for the first and second serial ports.
The choice: 3E8/IRQ4, 2E8/IRQ3, 3F8/IRQ4, 2F8/IRQ3, Auto, or Disabled.
Onboard Parallel Port:
This item allows you to determine onboard parallel port controller I/O address
setting. The Choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7 or Disabled.
IS Onboard IDE Device: Press <Enter> to enter the
S
nternal PCI/IDE:
This chipset contains and internal PCI
I
T
DE Primary Master/Slave PIO:
The four IDE PIO (Programmed Input/Output) fields let yo
I
(0-4) for each of the four IDE devices that the onboard IDE interface supports. Modes 0 through 4 provide
successively increased performance. In Auto mode, the system automatically determines the best mode
for each device. The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3, or Mode 4.
rimary Master/
P
supports it and the operating environment includes a DMA driver (Windows 95 OSR2 or a third-party IDE
bus master driver). If both of your har
se
ce: Auto or Disabled.
SIS Onbo
SIS USB Controller:
Select Enabled if your system contains a Universal Serial Bus (USB) controller an
h
USB 2.0 Supports:
Select Enabled if your system contains a Universal Serial Bus 2.0
USB pe
s.
The Choice:
Enabled or Disabled.
SiS AC97 Audio:
T
ripheral
SiS Serial ATA Controller:
Use this item to enable or disable the SiS Serial ATA Controller. The Choice:
Enabled or Disabled.
iS Serial ATA Mode:
This item allows you to set the SAT
S
Onboard LAN Boot ROM:
Decide whether to invoke the boot ROM of the onboard LAN chip. The choice:
Enabled or Disabled.
nboard Super IO Device:
O
Onboard FDC Controller:
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you want to use it. If you install add-on FDC or the system has no floppy drive, select
Disabled in this field. The choice: Enabled or Disabled.