4
UPGRADING MEMORY AND
REPLACING HARD DRIVE
Preparation for upgrade
A. Switch off all peripheral devices connected to the Mini PC.
B. Turn off the Mini PC and disconnect the power cord.
C. Open the top magnetic cover.OP: 200mV.
1. Replacing memory
To upgrade the memory, please be sure to select a memory
module that meets the following requirements:
DDR4: 2133/2400/3200MHz SO-DIMM
Note: If you intend to install only one memory module, please
install it in the lower memory slot.
Remove the old memory module Gently unfold the metal retaining
clips on each end of the memory slot to allow the module to pop
out of the slot (C). Hold the module by its edges and remove it
from the socket, then store it in its anti-static packaging.
Install the new memory module Firstly, align the notch on the
bottom edge of the memory module with the protrusion on the slot
holder, then insert the bottom edge of the memory module into the
socket (A) at a 45 degree angle. After inserting the module, push
down on the outer edge of the module until the retaining clip snaps
into place (B), and ensure the clips are securely in place.
Summary of Contents for QII-11515
