-10-
DEFROSTING AND TANKS CLEANING
The appliance makes the automatic defrosting.
We recommend a manual defrosting in the tanks ( in the upper tank on B-ICE N/P) when the frost
layer is too thick. Proceed as follows:
1) Place the goods in special refrigerated containers, kept at the same temperature.
2) Switch off the mains system by using switches (1) and (2) (see controls) and unplug the unit.
3) Put below a tray for draining water and remove the external and internal draining plug.
4) Leave the glass covers open; before cleaning the tank the inside temperature must be the same
as the ambient; clean and dry the tank’s walls with a soft cloth, using
neutral soap
.
Subsequentely,replace draining plug, plug in again and wait till the appliance reaches the right tem
-
perature before filling it again.
Warning!
Never use mechanical or electrical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
Do not
use jet of water to clean the cabinet: electrical wiring could be damaged.
For a good preservation of the cabinet’s body
a periodical cleaning is necessary
.
EXTERNAL BODY
: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES
: wash with warm water and mild detergent, rinse well and dry with
soft cloth.
Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL
: wash with warm water and mild detergent, rinse well and
dry with soft cloth;
under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES
: only use products specifically designed for glass cleaning;
It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
PERIODICAL MAINTENANCE
Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage. If the power supply cable is da
-
maged, don’t use the equipment and don’t try to repair it: to prevent any risk, it must be replaced by
the manufacturer, by a member of the after-sales service staff, or anyway by a person having similar
qualifications. In any case, none of the protective elements (the grill, the carter) must be removed by
non qualified staff. Absolutely avoid using the refrigerator without such protection.
The replacement
of neon tubes must be carried out only by an Authorized Service Center. The lamps have to
be replaced by identical lamps only.
B-ICE
MINI B-ICE
