Modello - Modèle - Model
Modell - Modelo
COUNTER 21 / COUNTER 50 / COUNTER 68 /
COUNTER 98
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
22/64
N° DOC
18. PROLONGED SWITCH OFF
When the unit is not used for a long time, please take note of the following procedures:
•
Unplug the unit.
•
Clean and dry the tank well.
•
Leave the glass door open to avoid possible formation of bad odours
•
Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric
agents.
19. PUTTING INTO OPERATION
If the cabinet has been sharply tilted while being sited or for mounting of
accessories, it must be left to stand for at least three hours before being started
to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that
of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR
WILL HAVE TO BE CONNECTED IS TO BE
PROTECTED BY A VERY SENSITIVE DIFFERENTIAL SWITCH
(Rc=16A,Dc=30mA); IT IS ALSO TO BE LINKED TO THE
GENERAL EARTHING PLANT. Earthing is necessary and
compulsory by law. Absolutely never use reduction units,
patch cords, adapters or multiple socket outlets to connect
the counter. DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck,
caught or stepped on, away from water and the other liquids and heat sources and
must not be damaged. In case of breakage of the power cable of the cabinet, it
must be replaced by the manufacturer or by instruction it change of it.
Follow the manufacturer’s instructions to install the unit, using qualified personnel
and complying with the electrical regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things
due to incorrect observance of this rule.
20. PROFESSIONAL REPAIR SERVICES
The services are provided by our service network that can be consulted in the contact area at the
web address:
www.eptarefrigeration.com.
21. SPARE PARTS
The spare parts and the information to repair the unit are available for at least 8 years after the
product is declared out of production at the following web address:
www.epta-service.com/
service/.
The credentials are provided on request by sending an email to:
servicesupport@ep-
tarefrigeration.com
