Modello - Modèle - Model
Modell - Modelo
GLEE MID 23
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
20/68
N° DOC
UM000427
5.
STORAGE AND DISMANTLING
WARNING! Use protective gloves during unpacking and installation
operations.
During unloading and movement operations, avoid tilting the machine and avoid sudden
manoeuvres. The unit is shipped anchored onto a wooden base and protected by corner
posts, cardboard top and nylon wrapping.
Keep all packaging away from children. For each
subsequent handling of the cabinet, the use of the wooden platform is recommended. Carefully
remove the packaging, taking care not to damage the components and not to throw away
those that will be needed for assembly.
ATTENTION! After unpacking, check that the appliance has not suffered
damage during transportation.
6.
CHOICE OF THE INSTALLATION SITE
In selecting the place of installation, ensure that the following instructions are observed, this
being vital for proper and troublefree working of the cabinet:
• Do not install the cabinet in the vicinity of heating radiators or other heat sources.
•
Do not install the cabint where it is exposed to direct sun light (e.g. through windows).
• Do not expose the refrigeration unit to air currents from fans, open doors, conditioning units.
•
Keep the air intake and outlet area around the plinth area of the cabinet clear of cartons
and other obstacles.
• It is necessary taht the condensing unit obtains a good circulation of air around it; also
the area around the condensing unit should not be obstructed by boxes or other objects;
keep a distance from the wall of
10 cm
. at least.
Air-Condi�on
7.
USE
THE APPLIANCE IS SUITABLE FOR FREEZING PRE-PACKAGED PRODUCE.
THE APPLIANCE IS INTENDED FOR THE SOLE STORAGE OF PRE-
PACKAGED PRODUCTS.
THE APPLIANCE IS INTENDED FOR THE SOLE STORAGE OF PRE-
PACKAGED PRODUCTS.
THIS APPLIANCE IS ONLY DESIGNED FOR USE AT A MAXIMUM ALTITUDE
OF 2000 METRES ABOVE SEA LEVEL.
THE APPLIANCE CANNOT BE USED FOR THE PRESERVATION OF
PHARMACEUTICALS.
The manufacturer cannot be held liable for damage caused by people, property or the
equipment itself due to display of products other than the afore-specified.
