Modello - Modèle - Model
Modell - Modelo
GLEE MID 23
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
25/68
N° DOC
UM000427
17. DEFROSTING AND TANK CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING
THE POWER PLUG BEFORE CLEANING.
If , however, the layer of frost on tank walls exceeds 4/5 mm in thickness, you should completely
defreeze the appliance as follows:
1.
Place the goods in special refrigerated containers, kept at the same temperature.
2.
Before cleaning the tank the inside temperature must be equal to the ambient temperature.
3.
Leave the doors open and begin the operation of tank washing when the tank temperature
is the same as the ambient temperature.
4. Proceed with washing and drying the internal chamber with a cloth using neutral PH
detergent and fresh water.
5. Clean the surfaces with a cloth, using neutral PH detergent, rinse and dry.
6. Avoid water entering into the appliance lighting units.
7.
Then plug the unit and wait till the appliance reaches the right temperature before filling
it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
Do not use jet of water to clean the cabinet: electrical wiring could be
damaged.
Never use mechanical devices or any other means to accelerate the
defrosting process, other than those recommended by the manufacturer.
18. TEMPERATURE SETTING AND CONTROL
Each refrigerating appliance is provided with an electronic control for automatic maintenance
of the appropriate pre-established temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement
the temperature:
1.
Unlock
the electronic controller by hold down “SET” button for 5 sec. (on the
display the word “UNLOCK” will appear).
2.
Press the (SET)
key
in order to see on display the temperature set point.
3.
Press the (
▲
) key or the (
▼
) key
in order to increment or decrement the
temperature set point.
4.
Press the (SET) key
in order to store the
new
temperature set point.
LIGHT SWITCH
(Short pressure)
