I A S U S _ S T E A LT H _ O P E R AT I N G I N S T R U C T I O N S _ v 6 _ 2 0 2 0
7
The Stealth can operate with two modules for audio output :
• The accoustic coil module
• The 3.5mm recess/thin audio connector module.
To use the Stealth with helmet speakers or earbuds, please connect the 3.5mm recess/thin audio
connector to the throat mic. Each module can be switched and replaced as follow:
To properly attach either module, it needs to be turned clockwise and tightened firmly until the IASUS
logo is horizontal and right side up. This position ensures proper alignment with the electrical contacts. It
should be tightened to the point where it will not turn anymore in order for the silicon ring to maintain a
waterproof seal.
NOTE:
When connecting helmet speakers or earbuds to the iASUS helmet speaker’s 3.5mm jack module, be
sure to insert the plug all the way into the module until a click is felt to confirm a waterproof seal has been estab
-
lished.
3
•
Turn clockwise to install the
new module and tighten firmly.
1
•
Turn counter-clockwise
to unscrew the module
2
•
Remove the currently
installed module
I N T E R C H A N G E A B L E M O D U L E S
