6
Power Supply
-
Connect the Power Adapte
r
Connect one end of the AC adapter to the DC IN jack of the camera the other
end to the wall outlet. Make sure power plug is pushed all the way in.
-
Battery Recharge
The charging starts when the LED turns red. Charging is
finished when the LED turns off (after approx. 4 hours max.)
USB Receiver Setup
There is a driver
/ NVR software (WUSB Camera) CD in the package. Install
the WUSB Camera software before inserting the USB Receiver into one USB
port of PC.
Make sure the OS of PC is in line with requirements.
Fine Tuning
- Adjust the camera’s viewing angle according to the illustrations.
- Move the camera to make adjustment.
- To keep the USB receiver position above the desktop for best result. You can
connect USB receiver to the USB extension cable supplied to adjust the position
of USB receiver.
Installing supplied software
1. Insert CD-ROM with supplied software.
The setup menu will start.
• Double-click “My Computer” on the desktop, double-click “set up”,
install the software on C:
2. Click on the “Recommended Installation”.
•
All necessary software will be installed.
•Only the software compatible with the PC in use will be displayed.
•Proceed with installation according to messages appearing on the screen.
3. Click “Finish” to complete the software installation.
When the software is well installed, you can find
on the
desktop.
Copy Right
©
IA Technologies 02/23/2011
Webpage :
www.iat101.com
;
www.ia-tecs.com