Page 6
Manual
ibaBM-FOX-i-3o
©
iba AG 2009
2
Package Contents
The package includes the following items:
T
ibaBM-FOX-i-3o device with 2-pole Phoenix connector (for power supply)
T
ibaBM-FOX-i-3o
manual
3
System Requirements
T
Power supply 24 V DC
T
Signal source (outputs of ibaPADU, ibaLink-SM- or ibaFOB card)
T
Signal target (inputs of ibaPADU-8-O, ibaLink-SM- or ibaFOB card)
T
PC, equipped with ibaFOB-card and software ibaPDA, ibaLogic or ibaQDR
T
The supported baud rates range from 2.0 Mbit/s up to 5 Mbit/s
4
Installing the Device
Install:
Make sure the DIN-rail clip at the back of the device fits properly into the top edge of
the DIN-rail, then lightly press the device down – back into the DIN-rail. The device
will easily snap into the DIN-rail. After that connect the power supply and all necessary
connectors.
Removing the device:
First remove all connectors from the device.
With one hand press the top of the device slightly down to ensure that the device later
will be secure between both hands.
Place two fingers of the other hand under the bottom of the device and slightly push
the device upward. The device will easily remove from the DIN-rail.
