11
3. Installing the Storage card
To install the Memory card
To have additional storage for your images, videos, music, and files, you can purchase a memory
card and install it into your device.
1. SD card slot is located nearby HDMI port.
2. Locate the memory card slot on the upper part of the exposed right panel.
3. Insert the memory card into the slot with its gold contacts facing down until it clicks into place.
Note:
To remove the memory card, push outside & eject it from the slot.
Charging the Battery
New batteries are shipped partially charged. Before you start using your device, it is
recommended that you charge the battery. Some batteries perform best after several full
charge/discharge cycles.
The battery can be charged and discharged many times, but it will eventually wear out. When the
standby times are noticeably shorter than normal, get the battery replaced. Use only iBall
approved batteries, and recharge your battery only with iBall approved chargers designated for
this device. If a battery is being used for the first time or if the battery has not been used for a
prolonged period, it may be necessary to connect the charger, then disconnect and reconnect it
to begin charging the battery. If the battery is completely discharged, it may take several minutes
before the charging indicator appears on the display .
Note:
Please use DC Round PIN charging cable & AC adapter provided with your device to
charge the device.
Connect the DC Round Pin cable to the DC charging port on your device, and then plug in the
AC adapter to an electrical outlet to start charging the battery.
As the battery is being charged while the device is on, a charging icon appears in the title bar of
the Home screen. After the battery has been fully charged, a full battery icon appears on the title
bar of the Home screen.
Warning!
• As a safety precaution, the battery stops charging before it overheats.
4. Starting up the Device
Power on/off
To power off your Slide, press & hold the POWER key. On release, the options menu opens.
Select „Power off‟ from the given options and confirm. This will turn off the device.
To power on again, press & hold the POWER key. The iBall power start up animation will appear
on the screen indicating that the device is starting. It takes around 1 minute to completely reboot
the device.
Screen sleep
After a period of inactivity, your screen will go to sleep (display will turn black). In sleep, your slide
uses less battery power. You can control this behavior by following the below mentioned steps:
Set screen timeout period
