45
➤➤
Adjustment Man
ual
EN
Memo
Loosen the strings suffi ciently before you install or remove tremolo springs. Be aware that if you
•
remove all of the springs, the tremolo unit will detach from the guitar.
To reattach the tremolo, insert the knife edge of the tremolo securely into the groove of the stud bolts,
•
and then install the tremolo springs.
Stud lock
The Edge/Lo-Pro Edge tremolo bridge uses a stud lock
mechanism.
Insert an Allen wrench (1.5 mm) through the hole in the
1.
top of the stud bolt.
Turn the stud lock bolt clockwise, tightening it until it
2.
contacts the anchor nut and can no longer rotate.
The stud lock will be released when you loosen the stud lock bolt.
※
Adjusting the action
To adjust the height of the entire tremolo unit, use an Allen wrench
(4mm) to turn the stud bolts located at the left and right of the
tremolo unit. (It is not possible to make adjustments for each string
individually.)
Memo
Make sure that the stud lock is released before you adjust the
•
action.
Adjusting the intonation
Use an Allen wrench (3 mm) to loosen the pressure
1.
pad bolts of the locking nut, and loosen the strings
suffi ciently.
Use an Allen wrench (2 mm) to loosen the saddle
2.
lock bolts, and adjust the saddle position.
Before checking the intonation, fi rmly tighten the saddle lock
※
bolts and tune the guitar correctly. When you’ve fi nished
making adjustments, tighten the saddle lock bolts and the
pressure pad bolts of the locking nut.
Prestage Manual.indb 45
Prestage Manual.indb 45
8/9/2013 11:28:23 AM
8/9/2013 11:28:23 AM
