12
IB919 Series User’s Manual
2.1
Essential Installations Before You Begin
Follow the instructions below to install the memory.
2.1.1
Installing the Memory
The IB919 series supports two DDR4 memory sockets for a maximum total
memory of 32 GB. To install the modules, locate the memory slot on the
board and perform the following steps:
1.
Align the key of the memory module with that on the memory slot and
insert the module slantwise.
2.
Gently push the module in an upright position until the clips of the slot
close to hold the module in place when the module touches the bottom
of the slot.
To remove the module, press the clips outwards with both hands, and the
module will pop-up.
Summary of Contents for IB919 Series
