14
Installation
Installing WLAN antenna (Optional)
SI-18 reserved one SMA connector hole for WLAN (wireless LAN) antenna
connection on I/O side. It means you can only use one antenna solution WLAN card.
For 802.11n solution, you can only have up to 150Mbit/s performance. You can have
WLAN feature by purchase WLAN set from your sales representative. And follow
below procedure to install the WLAN feature by yourself.
Before you start to install WLAN antenna and card please:
-
Complete remove DC power source from SI-18.
-
Please ensure you have good ESD protection environment and if possible please
wear ESD protection equipment and have well grounding connection.
1.
Upside-down SI-18 and let bottom side face to you.
2.
Remove all M3 screw of bottom chassis (12 pieces) with properly screw driver
from point A.
3.
Rotating SI-18 to let bottom side face to your body.
4.
Using screw driver to pinch out the knock-out metal-plate of SMA antenna hole
from point B. To avoid the metal fall in system, please pinch out the metal-cover
with same direction as the figure below.
A
A
A
A
Summary of Contents for SI-18 Series
