18
Installing the memory
The motherboard supports two DDR3 memory socket for a maximum total memory of
4GB in DDR3 memory type.
Installing and Removing Memory Module (CN1)
To install the DDR3 modules, locate the memory slot on the board and perform the
following steps:
1.
Hold the DDR3 module so that the key of the DDR3 module align with those on
the memory slot.
2.
Gently push the DDR3 module in SOCKET position until the clips of the slot
close to hold the DDR3 module in place when the DDR3 module touches the
bottom of the slot.
3.
To remove the DDR3 module, press the clips with both hands.
Summary of Contents for SI-18 Series
