Hardware Configuration
SI-324 User Manual
11
2
2.1.2
Mini-PCIe & M.2 Cards
1. Locate the mini-PCIe or M.2 slot inside the device.
2. Align the key of the mini-PCIe card to the mini-PCIe interface, and insert
the card slantwise. (Insert the M.2 card in the same way.)
3. Push the mini-PCIe card down and fix it with the an M2 screw. (Fix the
M.2 network card with an M3 screw.)
Mini PCIe:
M.2:
2.1.3
WiFi / 3G / 4G Antenna Installation
Thread the WiFi / 3G / 4G antenna extension cable through an antenna hole
of the front I/O cover and fasten the antenna as shown below. Then apply
adhesive to the edge of the hex nut behind the front I/O cover to prevent the
extension cable from falling if the cable becomes loose.
1. Thread and fasten the hex nut and the
washer. Then install the antenna.
2. Apply adhesive around here.
Info:
The diameter of the nut is around 6.35 mm (0.25”-36UNC).
