DIP SWITCH
Cleaning function
Cleaning function connected in ON position.
When the rotor has stopped for 30 minutes, the cleaning function is
activated and the rotor rotates at min. rpm for 10 seconds.
Rotation monitor
Rotation monitor set to ON position.
High speed*)
The rotor rotates at the set max. rpm when the switch is set to ON.
After a test run, make sure the DIP switch is set to OFF.
Low speed*)
The rotor rotates at the fixed minimum rpm when the switch is set to ON.
After a test run, make sure the DIP switch is set to OFF.
*)
Manual operation (test mode)
OPERATIONAL INDICATIONS
On/alarm
Lit with fixed light
It flashes when the control unit has tripped.
Run
Comes on when the motor is to rotate, i.e. when the input signal exceeds
the threshold value.
Rotation
Flashes when the magnet passes the magnetic sensor, regardless of the
“Rotation monitor” DIP switch setting.
Flashes even if the input signal is lower than the threshold value.
7
Summary of Contents for F21009301
Page 2: ......
Page 15: ...PERSONAL NOTES 13 ...
