AS1375MP-960
Page 22
20/11/2006
4. Relieve system pressure by opening the Fast
Rinse Drain Valve (the fifth valve back from the
control) with a screwdriver, Figure 3.
5. Using a screwdriver, unscrew and remove the
injector screen and the injector cap, Figure 4.
6. Clean the screen with a fine brush. Flush with
water until clean
7. Using a needle-nose pliers, pull the injector
straight out.
8. Flush water into the injector screen recess of the
valve body to flush debris out through the injector
recess.
9. Clean and flush the injector.
10. Lubricate the o-rings on the injector, injector cap,
and injector screen with silicone lubricant
(Autotrol part number 156A59).
11. Reinstall the injector, injector cap and injector
screen (refer to the caution note).
12. Reinstall cover, reconnect electric power, and
reset the time of day.
13. Slowly open the water supply valve or return the
bypass valve(s) to the "not in bypass" position.
Maintaining the Drain Line
The drain line discharges and brine during the
regeneration cycle. Typically, the line drains into your
floor drain or laundry tube. The installer should plumb
the drain line according to local codes, leaving a one
or two inch air gap between the end of the drain line
and the drain opening. Figure 5.
Be sure that the drain line remains unrestricted so the
regeneration water and brine can flow freely to the
drain. Do not set objects on the drain line that could
crimp the line and restrict flow.
Figure 2
Figure 3
Figure 4
Caution
Do not overtighten the plastic cap. Seat the cap
lightly into position. Overtightening can cause
breakage of the plastic cap, which may not be
evident immediately.
Figure 5
Figure 7 - Air Check