AS1375MP-960
Page 8
20/11/2006
IF THE TIME IS “PM”
Wait till the green light moves to the “TIME OF DAY” position
Immediately press “SET” button.
The last digit will
blink
–
Using the
ï
button, key in the current
last minute
figure.
Eg, PM 03.2
5
– Key in ‘5’
Press the
ï
button - the first
minute
digit will
blink
.
Using the
ñò
buttons, key in the current first
minute
figure.
In example 03.
2
5 – Key in ‘2’
Press the
ï
button – the
second hour
digit will
blink
.
Using the
ñò
buttons, key in the current
second hour
figure.
In example 0
3
.25 – Key in ‘3’
Press the
ï
button – the first hour digit will blink. Using the
ñ
button only keep on
pressing slowly until a little dot appears in the top left hand corner of the display
under ‘PM’ – if the display is blinking and shows ‘1’ keep on pressing
ñ
button until
.
0
appears, the press “SET” button.
Note: If the actual time is after 10 PM then the
ñ
button would not be further pressed
and the display left on
.
1.
Note: If when programming the figures in, the display reverts back to the green button
moving between “time of day” and “capacity”, it just means that you have taken too long
to program the settings in. Do not worry all you need to do is to press the “SET” button
when the green light is against the setting and start over inputting the figures in a bit
faster.
Make sure at the end of programming that the “set” button is pushed.
þ
þ
þ
þ
þ
